Bevel Code Selection window
- Last UpdatedFeb 24, 2026
- 2 minute read
Specify the bevel preparation type using a Bevel Code. The Bevel Code contains the information about the bevel type and its required parameters. Once a bevel code is specified via manual input or a selection dialog the selected bevel type is shown in an image and corresponding values shown too.
Filter
Filters the available bevel standard codes defined in Paragon.
Use the entry field to narrow the list by entering a bevel code or bevel number.
Use the dropdown list to filter bevel codes by bevel type. Available options include: All Bevels, I-Bevel, V-Bevel, Y-Bevel, K-Bevel and X-Bevel.
Butt
|
|
Defines whether to narrow the Filter list by butts or not. If you do not select the Butt checkbox, the list is narrowed by butts. |
Fillet
|
|
Defines whether to narrow the Filter list by fillets or not. If you do not select the Fillet checkbox, the list is narrowed by fillets. |
Code
Type
Diagram
Parameters
Apply
Once the bevel preparation and/or excess are specified its possible to apply them to the limit(s) of a panel. For this, the user can select one or more panels and the corresponding limits in the 3D view.
Created bevel preparations and/or excess is visible in the 3D model if the Visibility for bevels and/or edges is switched on.
Information about bevel preparations and excess are available via property grid.
It is also possible to modify their properties in the property grid.
