Splice Section at Panel Intersection
- Last UpdatedMar 05, 2026
- 2 minute read
Splices sections at a panel intersection.
On the Sections tab, in the Modify group, select Splice.
You are prompted to Select element(s) to splice
Note:
The prompt does not display if the section element is already selected.
Click to identify a section to splice.
You are prompted to Select element(s) to splice or <Next>
Note:
The prompt does not display if the section element is already selected.
The prompt is repeated, allowing you to identify multiple sections to splice.
Input N at the prompt and press Enter to specify the splice point.
You are prompted to Select panel to splice with or <Plane (1 point)>
Click to identify an intersecting panel to define a splice point.
The sections are spliced at the intersecting panel points.
Throughout the splice process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Next |
Press the down arrow key and select Next to proceed to the next splice process. |
|
Plane (1 point) |
Press the down arrow key and select Plane (1 point) to splice a section using a plane defined by one picked point. Refer to Splice Section using a Plane for further information. |
|
Plane (2 points) |
Press the down arrow key and select Plane (2 points) to splice a section using a plane defined by two picked points. Refer to to Splice Section using a Plane for further information. |
|
Plane (3 points) |
Press the down arrow key and select Plane (3 points) to splice a section using a plane defined by three picked points. Refer to to Splice Section using a Plane for further information. |
The new GENSEC elements display in the Model Explorer.
